Leaky garden hoses are common problems that many homeowners eventually have to deal with, but did you know that instead of replacing your entire hose you can usually perform some simple DIY repairs for a fraction of the cost?
It’s true, and if you’ve never taken the time to learn how you can solve leaky hose issues before then make sure to keep reading to discover how you can save money and resolve your plumbing issues with speedy DIY garden hose repairs:
Locate the Source of the Leak
The first step is to figure out where your leak is located; if you aren’t sure, is to simply turn on the flow of water to your hose while the spray nozzle is attached.
This buildup of pressure inside the hose will cause any leaky areas to become immediately apparent.
If the leak is occurring somewhere along your hose, make sure to mark the area using a permanent marker so that you can easily find it again when the water is shut off.
Is the issue with the hose connector?
If there’s a problem with your hose connector, then the gasket may be the source of your headaches. The first step to follow here is to inspect the gasket to see if it needs to be replaced. If not, then run out and buy a hose barb kit, which will allow you to replace the end of the hose with a brand new one.
Is the issue with your hose?
If a section of your hose
is leaking, it can easily be resolved by removing the compromised section of hose with a pair of garden shears. Then, head to your local hardware store and pick up a hose repair kit, and use the included clamps and coupler provided in the kit to reattach the sections of hose.
Resolve Problems with Your Hose Bib
The faucet which protrudes from your home and connects your hose to your water supply, which is also referred to as the “hose bib” can be the source of many homeowners’ distress when it comes to leaks.
Luckily, replacing your hose bib is terribly easy: simply pull the hose bib from the wall and remove the washer using a screwdriver. Then, replace the old washer with a new one and screw the hose bib back into place.
If this doesn’t work, take a look at your packing nut and determine if it looks worn-out or loose. Use a wrench to tighten it and see if the leak persists; if it does, use Teflon tape and wrap it around the stem of the faucet. Then, push the packing nut back over it and attach the hose as you normally would.
Trust in our expertise and dial 626-962-0885 for fast, dependable plumbing solutions in West Covina, CA from the professionals at Daniel Cordova Plumbing, Drain & Sewer.